Crunch Speaker GRP52C User Manual

 
SPEAKER LOCATION AND MOUNTING TIPS  
THE FIRST STEP IS THOROUGH PLANNING BEFORE THE  
INSTALLATION BEGINS.  
THE SPEAKER SCREW HOLE CONFIGURATION WILL WORK WITH  
MOST DOMESTIC AND FOREIGN VEHICLES.  
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE PROPER  
IMAGING AND MAXXIMUM PERFORMANCE.  
Factory Speaker Replacement Location and Installation  
1. Before you alter the vehicles interior materials, be sure there is  
adequate room and clearance for the speaker depth to clear the  
windows and other moving parts. (See speaker measurement page).  
2. If you are using the speaker wires provided in this kit, be sure  
to route wires through the factory door grommet as shown in the  
speaker mounting diagram.  
3. After securing the speaker and checking clearances, connect  
the red/black speaker audio wires to the correct speaker + and -  
spade terminals.  
Custom Speaker Location and Installation  
1. Follow steps 1-5 above.  
2. Use the speaker mounting diagrams and speaker hole cut-out  
dimensions on the following pages.  
3. Always mount the left and right side speakers on the same plane.  
This means that each speaker should be the same height from  
the floor and same distance from the firewall. Do not mount one  
speaker higher, lower, further forward or further behind the other.  
3. It is always best to keep the tweeter (component speakers) as close  
to the mid range driver as possible. Typically with-in 12”.  
The tweeters tend to sound best when aimed towards the rear center  
of the vehicle.  
2
 
COMPONENT MOUNTING & WIRING PROCEDURES  
Inner Metal Door Panel  
Interior Door Panel  
Door Mount  
Tweeter  
Speaker  
Speaker Grill  
Speaker Screws  
Factory Grommet  
Speaker Wires  
Inner Metal Door Panel  
Wire Routing  
Wire Connections  
MID BASS  
+
RED  
+
To amplifier  
+ & - output  
C R U N C H  
GROUND POUNDER  
In-Line Passive Crossover  
BLACK  
TWEETER  
3
 
COAX & 3-WAY MOUNTING & WIRING PROCEDURES  
Rear Deck Mount  
Speaker Grill  
Mounting Screws  
Spacer Ring  
Speaker  
Inner Metal Door Panel  
Interior Door Panel  
Door Mount  
Speaker  
Speaker Grill  
Speaker Screws  
Factory Grommet  
Speaker Wires  
Wire Routing  
Inner Metal Door Panel  
Wire Connections  
Red  
+
Amplifier  
-
Black  
4
 
SPEAKER DIMENSIONS  
GRP5.2C / GRP6.2C Tweeter  
.47”  
1.79”  
GRP52CX / GRP5.2C  
GRP62CX / GRP6.5C  
GRP693  
5
 
6
 
Maxxsonics Limited Warranty  
As the manufacturer of Maxxsonics, Autotek, MB Quart, Crunch and Hifonics car audio  
products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier  
to be free from defects in material and workmanship for one (1) Year from date of purchase.  
All other parts and accessories of the system are warrantied to be free from defects in  
material and workmanship for one (1) year from date of purchase. Maxxsonics will  
repair or replace at it’s option and free of charge during the warranty period, any system  
component that proves defective in materials and workmanship under normal installation,  
use and service provided that the product is returned to the authorized Maxxsonics dealer  
from where it was purchased. A photo copy of the original receipt must accompany the  
product being returned.  
Valid purchase receipts will contain the name and address of the authorized reseller.  
Any damage to the product as a result of misuse, abuse, accident, incorrect wiring,  
improper installation, alteration of date code or bar code labels, revolution, natural  
disaster, or any sneaky stuff because someone messed up, repair or alteration out side  
of our factory or authorized service centers and any thing else you have done that you  
should not have done is not covered.  
This warranty is limited to defective parts and specifically excludes any incidental  
or consequential damages connected therewith. This warranty is not to be construed  
as an insurance policy.  
Warranty on installation labor, removal, re-installation and freight charges are not the  
responsibility of Maxxsonics USA Inc.  
Warranty products damaged as a result of insufficient or improper packing materials  
are not covered by this limited warranty and such damaged product will be returned  
“as is” at the expense of the owner.  
7
 
 

Clover Electronics Digital Camera Z670 User Manual
Clover Electronics DVR LCD221616 User Manual
Coleman Camping Equipment 2000001132 User Manual
Conair Blender GB WSB User Manual
Creative MP3 Player FX200 User Manual
Delfield Refrigerator SAR1 S User Manual
Electro Voice Speaker System ND6 16 User Manual
Frontier Labs Utility Vehicle BB2048 User Manual
Gateway Computer Monitor FPD1975W User Manual
GE Double Oven JGRP20 User Manual